CRU 2 Bay Enclosure SCSI Ultra F/W 160 0023-1000-9100 プリント

The DataPort 2 & 4 Bay Enclosures include the following pieces.  
If any items are missing or damaged please contact CRU for a 
replacement.

4 Bay Enclosure Package Contents
  1 - External Enclosure
  1 - U320 LVD Terminator
  1 - External U320 VHD to UVHD Cable
  4 - Hard Drive Mounting Rails
  1 - Installation Guide

2 Bay Enclosure Package Contents
  1 - External Enclosure
  1 - U320 LVD Terminator
  1 - External U320 VHD to UVHD Cable
  2 - Hard Drive Mounting Rails
  1 - Installation Guide
 

1.  Remove the cover of the DataPort Enclosure.  Remove the rear 

screws and slide the cover off the back of the enclosure.

2.  Remove the front bezels if you are installing a device that 

needs external access such as a tape back up unit or CD-ROM.

The DataPort 2 and 4 Bay SCSI Enclosures allow external SCSI devices to be easily 

added to any system with an available external SCSI channel.  The DataPort Enclo-

sures can provide additional tape backup units, CD-ROMs or non-removable hard 

drives to a server.  The DataPort 2 and 4 Bay Enclosures will support most full height 

SCSI tape backup units.  For adding removable DataPort hard drives please contact 

CRU at www.CRU-DataPort.com.

3.  Set the SCSI ID on the device or remove the jumpers and use 

the provided SCSI ID selector switch.  Do not use SCSI ID #7, it 
is used by SCSI Host Bus Adapters.  

4.  Install the hard drive mounting kits and secure them with the 

provided screws.  Otherwise install the SCSI device into the 
enclosure and secure them with the provided screws.

5.  Connect the data and power cables to the back of the SCSI 

devices.  If needed connect the SCSI ID selector switches.

6. Slide the cover back on and secure it with the screws.

7. Connect the external power cable, the SCSI cable and 
    Terminator.

Your enclosure is now setup and ready for use.