Thermador DWHD651JFP 使用とお手入れ
5
Dishwasher Setup
Water Softening System
Your dishwasher requires soft water to ensure proper washing results and is
equipped with an internal water softening system. However, if you have a house-
hold water softening system, the internal system provided is not needed.
For the water softening system to function properly, it will need to use dish-
washer water softening salt. The amount of salt dispensed can be set from
“H:00” to “H:07”. Salt is not required at H:00 (default factory setting). The
amount of salt required depends on the degree of hardness of your tap water.
See Table 1.
To change the water softener setting:
1
equipped with an internal water softening system. However, if you have a house-
hold water softening system, the internal system provided is not needed.
For the water softening system to function properly, it will need to use dish-
washer water softening salt. The amount of salt dispensed can be set from
“H:00” to “H:07”. Salt is not required at H:00 (default factory setting). The
amount of salt required depends on the degree of hardness of your tap water.
See Table 1.
To change the water softener setting:
1
Open the door and press the ON/OFF button.
2
Hold down the A button (see page 4) and press START until the display
indicates “H:00”.
3
Release both buttons and press the C button to select the desired setting.
4
Save the selected setting by pressing START and close the door.
Using the water hardness test strip
Salt
Refill the salt container, using the included funnel to pour, right before turning on the
unit to ensure that salt overflow is immediately washed away. This prevents corrosion.
See Figure 1.
1
unit to ensure that salt overflow is immediately washed away. This prevents corrosion.
See Figure 1.
1
Open the screw cap of the salt container.
2
Fill the container with water (only required when turning on the unit for the first time).
3
Add dishwasher salt until the water is displaced and runs out.
4
Refill with salt as soon as the symbol or “Salt” LED is lit (model dependent).
Notice: Never fill the salt dispenser with detergent. It will destroy the water softening
system. To prevent corrosion, refill with salt and immediately begin any cycle.
Note: Do not use salt tablets or any salt other than dishwasher water softening salt.
system. To prevent corrosion, refill with salt and immediately begin any cycle.
Note: Do not use salt tablets or any salt other than dishwasher water softening salt.
For more information about ordering salt please contact Customer Service.
Dip the test strip into tap water for a second. Shake off
excess water and wait approximately 1 minute before
comparing results.
After 1 minute the
test strip will show
you the correct
setting
Setting of
internal water
softener
Fill water
softener with
salt?
0
H:00
no
1
H:00
no
2
H:02
yes
3
H:04
yes
4
H:06
yes
Figure 1