Napoleon P500RSIBNSS オーナーマニュアル

www.napoleongrills.com

This Gas Barbecue Is Certified Under Canadian And American National Standards, CSA 1.6a-2008 and ANSI 

Z21.58a-2008 respectively for Outdoor Gas Grills and should be installed to conform with local codes. In 

absence of local codes, install to the current CAN/CSA-B149.1 Propane Installation Code in Canada or to the 

National Fuel Gas Code, ANSI Z223.1 in the United States. 
If a rotisserie motor is used, it must be electrically grounded in accordance with local codes or, in absence of 

local codes, with the current CSA C22.1 Canadian Electrical Code in Canada or the National Electrical Code, 

ANSI/NFPA 70 in the United States.
CALIFORNIA PROPOSITION 65: The burning of gas fuel creates by-products, some of which are on the list as 

substances known by the State of California to cause cancer or reproductive harm.  When cooking with gas, 

always ensure adequate ventilation to the unit, to minimize exposure to such substances.

If the gas grill is being supplied with propane from a portable cylinder, a regulator specified by the manufacturer 

must be used.  The regulator must supply a pressure of 11 inches water column (0.39 PSI) to the gas grill and 

have a QCC1 type fitting. Cylinders to be used with this unit must be supplied with a QCC1 cylinder valve.  A QCC1 

cylinder has a positive seating connection, which will not allow gas flow until a positive seal has been achieved.  

It is also equipped with an excess flow device.  In order to attain full flow to the grill, the valves must be in the off 

position when the cylinder valve is turned on.  
A dented or rusty cylinder may be hazardous and should be checked by your propane supplier. Never use a 

cylinder with a damaged valve. Use only a propane supply cylinder constructed and marked in accordance 

with the specifications for LP-gas cylinders of the National Standard of Canada, CAN/CSA-b339, Cylinders, 

Spheres and Tubes for Transportation of Dangerous Goods; and Commission, as applicable or the Specifications 

for LP-Gas Cylinders of the U.S. Department of Transportation (D.O.T.). Cart models have been designed for 

use with a 20 lb (9.1 kg) size propane cylinder only (not supplied).
The propane cylinder must be provided with a cylinder connection device compatible with the connection 

for outdoor cooking appliances.  The propane cylinder must be provided with a shut-off valve terminating in 

a propane cylinder valve type QCC1, and a safety relief device having direct communication with the vapor 

space of the cylinder. The cylinder supply system must be arranged for vapor withdrawal and the cylinder 

shall include a collar to protect the cylinder valve.  The cylinder shall incorporate a listed OPD (overfill 

protection device).  Do not store a spare LP-gas cylinder under or near this appliance. Never fill the cylinder 

beyond 80 percent full.  If the preceding information is not followed exactly, a fire causing death or serious 

injury may occur.

Propane Cylinder Installation: Set cylinder into hole in bottom shelf. Other cylinders may be acceptable provided 

they fit properly into the tank retaining ring.