Scholtes LFDS3XL60HZ 使用とお手入れ

 FAULT 

DESCRIPTION 

E1 

 

Acquastop failure 

The anti-flooding system has tripped. Activates in case of water leaks. Contact the technical 

assistance service. 

E2 

 

Safety level 
The system limiting the water level in the dishwasher has tripped. Interrupt the current program 

and switch off the dishwasher. Switch it back on again, program a new cycle and press start. If 

the problem persists, contact the technical assistance service. 

E3 

 

Water heating malfunction 
The water is not heated or is incorrectly heated. Repeat the washing program; if the problem 

persists, contact the technical assistance service. 

E4 

 

Water temperature monitoring malfunction 

Interrupt the current program and switch off the dishwasher. Switch it back on again, program a 
new cycle and press start. If the problem persists, contact the technical assistance service. 

E5 

 

Water intake malfunction 
The appliance does not take in water or does so incorrectly. Make sure the water connections 

are correct, that the water supply tap is open and that the filter is not clogged. If the problem 
persists, contact the technical assistance service. 

E6 

 

Water pump-out malfunction 

The appliance does not pump out the water or does so incorrectly. Make sure the drain hose is 

not kinked or crushed and that the siphon and filters are not clogged. If the problem persists, 
contact the technical assistance service. 

E7 

 

Turbine flow-regulator malfunction 

The appliance is unable to precisely measure the quantity of incoming water. Interrupt the 
current program and switch off the dishwasher. Switch it back on again, program a new cycle 
and press start. If the problem persists, contact the technical assistance service. 

E8 

 

Alternate washing system malfunction 
Interrupt the current program and switch off the dishwasher. Switch it back on again, program a 

new cycle and press start. If the problem persists, contact the technical assistance service. 

E9 

 

Water intake system malfunction 

Contact the technical assistance service.

 

 

The dishwasher can signal a number of malfunctions by turning on various indicator lights, as described below (see
following table):

If an alarm situation occurs, the dishwasher interrupts the current program and signals the fault.

•

Alarms 

E1, E2, E3, E4, E8, E9 immediately terminate the current program.

•

Alarms 

E5, E6 interrupt the current program and, after the problem has been eliminated, resume the cycle.

•

Alarm 

E7 is displayed at the end of the cycle which, however, is completed given that it does not jeopardize

dishwasher operation.

To "reset" an alarm:

•

open or close the door, or switch the appliance on and back off again. At this point, the dishwasher can be
programmed again.

If the fault persists, contact the Authorized Technical Assistance Service.