Frigidaire FFHS2622M オーナーマニュアル

18

Your refrigerator is equipped with a water filtering

system. The water filter system filters all dispensed

drinking water, as well as the water used to produce ice. 

The water filter is located at the top right side of the

fresh food compartment. 

Do not use with water that is microbiologically unsafe or 

of unknown quality without adequate disinfection before 

or after the system. Systems certified for cyst reduction

may be used on disinfected waters that may contain 

filterable cysts.

 •  Rated Capacity - 200 gallons/757 liters for

TM

ice and water filter

 •  Rated service flow - .50 gallons per minute
 •  Operating Temp.: Min. 33°F, Max. 100°F
 •  Maximum Rated Pressure - 100 pounds per square

inch

 •  Recommended Minimum Operating Pressure: 30

pounds per square inch

TM

It is not necessary to turn the water supply off to change 

the filter. Be ready to wipe up any small amounts of water

released during the filter replacement.
  1  Turn Off the ice maker.   
  2  Remove the filter by pushing on the end/face of the

filter.

  3  Slide the old water filter cartridge straight out of the

housing and discard it.

  4  Unpackage the new filter cartridge. Using the

alignment guide, slide it gently into the filter housing

until it stops against the snap-in connector at the 

back of the housing.

  5  Push firmly until the cartridge snaps into 

engages the snap-in connector). 

  6  Press a drinking glass against the water dispenser 

while checking for any leaks at the filter housing.

Any spurts and sputters that occur as the system 

purges air out of the dispenser system are normal.

  7  After filling one glass of water, continue flushing the

system for about four (4) minutes.

  8  Turn On the ice maker.
  9  Press and hold the Water Filter button on the Ice 

& Water Dispenser control panel for three seconds. 

When the display changes from “red” to “Green,” 

the status has been reset.

To order your replacement filters, please visit our online

store at www.frigidaire.com/store, by calling toll-free 

at 877-808-4195, or by visiting the dealer where you 

purchased your refrigerator. Electrolux recommends 

that you order extra filters when you first install your

refrigerator, and that you replace your filters at least once

every six months. 
Here are the product numbers to request when ordering: 
  PureSource 3

TM 

 

Water Filter

  Part #WF3CB

In general, you should change the water filter every six

months to ensure the highest possible water quality. 

Water Filter Status on the user interface prompts you 

to replace the filter after a standard amount of water

(200 gallons/757 liters for PureSource 3

TM

)

 

has flowed

through the system.
If your refrigerator has not been used for a period of time 

(during moving for example), change the filter before

reinstalling the refrigerator.

The PureSource 3

TM 

ice and water filter system

is tested and certified to NSF/ANSI Standards

42 and 53 for the reduction of claims specified

on the performance data sheet.