Zephyr ZMOE30AS 入門ガイド

1.  Measure from range top to hood bottom and mark line A.  (26” 

minimum from range top) .

2.  Plum and mark center line.

3.  Mark mounting height line B. (17 1/2” from line A)

4.  Mark mounting spread from C/L. (11 1/4”) 

5.  Fasten (2) M6 x 1-1/2” screws into studs on line B but do not 

tighten all the way.  Note: Wood blocking may need to be 
added behind the drywall if no studs are present.  Wall 
anchors may also be used but check local codes before 
using wall anchors.

6.    Remove tape and (2) screws securing electronics mounting 

bracket to hood. Reposition electronics mounting bracket as 
shown in (FIG B. #3) and secure to motor housing using the (2) 
previously removed screws.

7.    Remove (2) screws securing electrical junction box to 

electronics mounting plate. Remove junction box. (FIG. B #1)

8.  Remove the (1) aluminum mesh fi lter.

9.  Hang hood onto the mounting screws and hand tighten each 

screw. (FIG. A) Secure third M6 x 1-1/2” screw through inside of 
hood into wall for extra support. (FIG. A #2) 

10.  Center and attach duct cover mounting bracket to wall just 

below the ceiling or soffi t using (2) M6 x 1” screws.

11.  Install duct work and seal duct work with aluminum duct tape. 

Reinstall electrical junction box with cable lock and install the 
electrical. (FIG. B #2)

12.  Power up hood and check for leaks around duct tape.

13.  Place telescopic duct covers onto hood and extend inner (top) 

duct cover upwards and secure to duct cover bracket using (2) 
M3.5 x 8 screws. 

* If using hood in recirculating mode you must secure the air diverter 

plate onto wall before installing duct work and duct covers.  Turn 
to page 10 for more details.

11 1/4”

17 1/2”

Brackets are 

pre-installed

1

2

26” min

Cable Lock

2

1

3

Motor Housing

A cable locking connector (not supplied) might 
be required by local codes.  Check with local 
requirements and codes, purchase and install 
appropriate connector if necessary.