Zephyr ZMOM90AS 入門ガイド

Clean the hood surface periodically with hot soapy water and clean cotton cloth. Do not use corrosive or 
abrasive detergent, or steel wool/scouring pads which will scratch and damage surface.

For heavier soil use liquid degreaser.

After cleaning it is recommended that you use non-abrasive stainless steel polish/cleaners, to polish and 
buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.

Do not use any product containing chlorine bleach. Do not use “orange” cleaners.

The aluminum mesh fi lters installed by the factory are intended to fi lter out residue and grease from 
cooking.  They need not be replaced on a regular basis but are required to be kept clean.

After 30 hours of use the words “clean mesh fi lter” will illuminate on the control screen indicating time to 
clean the metal mesh fi lters.  Refer to instructions on page 12 on how to reset the indicator.  Filters may 
need to be cleaned more depending on cooking habits.

Remove and clean by hand or in dishwasher on low heat.  Spray degreasing detergent and leave to soak if 
heavily soiled.

Dry fi lters and re-install before using hood.

1. Push in on spring loaded handle

2. Pull down on fi lter hande to remove fi lter

Should fi lters wear out due to age and prolonged use,
replace with following part number:

ZMO-E30AS, ZMO-M90AS 

50200042 

          1