CoolIT Domino A.L.C. DM-1000 ユーザーズマニュアル
製品コード
DM-1000
S
YSTEM
A
LERTS
& T
ROUBLESHOOTING
System Alerts
Domino A.L.C. monitors system status and provides both visual
and auditory alerts if operation outside of acceptable ranges is
detected. In all alert conditions, the System Alert icon will flash
repeatedly and an auditory alert will sound for 10 seconds then
and auditory alerts if operation outside of acceptable ranges is
detected. In all alert conditions, the System Alert icon will flash
repeatedly and an auditory alert will sound for 10 seconds then
continue as a short beep once per minute until normal operating conditions
are restored.
are restored.
Failure Modes
Coolant Temperature icon flashing
1. Switch operation to Full mode if currently in Quiet or Performance
mode. If coolant temperature does not reduce to within acceptable
range or if already in Full mode, proceed to next step.
range or if already in Full mode, proceed to next step.
2. Power cycle computer. If failure mode persists after power cycling, con‐
tact CoolIT Systems for technical assistance.
Fan Speed icon flashing
1. Visually check to determine if fan is spinning. If it is not, contact CoolIT
Systems for technical assistance. If fan is spinning, proceed to next step.
2. Power cycle computer. If failure mode persists after power cycling, con‐
tact CoolIT Systems for technical assistance.
Pump Speed icon flashing
1. Power cycle computer. If failure mode persists after power cycling, con‐
tact CoolIT Systems for technical assistance.
www.coolitsystems.com/support
1‐866‐621‐COOL (2665)
P
RODUCT
C
ONTENTS
A. Radiator Module
B. Fluid Heat Exchanger (FHE)
C. LGA 1366 Backplate
D. LGA 775 Backplate
E. AMD CPU Retention Bracket
F. Fan Mounts (6)
G. Motherboard Stand‐offs (4)
H. 10‐24 Phillips Screws (4)
B. Fluid Heat Exchanger (FHE)
C. LGA 1366 Backplate
D. LGA 775 Backplate
E. AMD CPU Retention Bracket
F. Fan Mounts (6)
G. Motherboard Stand‐offs (4)
H. 10‐24 Phillips Screws (4)
A
B
Included with your Domino A.L.C. is everything pictured below (Fig 1 & 2).
Before you start the installation, please take a moment to verify that you
have all the parts necessary to complete the installation.
Before you start the installation, please take a moment to verify that you
have all the parts necessary to complete the installation.
Tools Required
•
#2 Phillips Screwdriver
Figure 1
Figure 2
C
E
D
F
G
H