Monogram ZXD30B インストール手順

• 

– Save these instructions

for local inspector’s use. Observe all governing
codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions with

your Owner’s Manual for future reference.

• Phillips screwdriver
• Drill and appropriate bits

(Brad point recommended for drilling through
wood panels)

• Custom panel
• Custom handle (optional)
• Adhesive recommended for metal to wood
• Adhesive recommended for plastic to wood

• Lamp Jewel
• Metal mounting panel

This kit contains a mounting panel to support a
trimless custom drawer front up to 3/4” thick. The
tubular handle can be reinstalled onto the custom
panel with longer screws (not provided). Or, the
original handle can be replaced with a custom
handle of your choice. (Handle is not supplied.)
Choose a custom handle to match or complement
cabinetry hardware.

IMPORTANT: The warming drawer should be
installed according to the installation instructions
packed with the product. The original drawer front
will be removed and replaced with a custom panel.

• Cut edges of the drawer panel will be seen and

must be finished for best appearance.

• The custom drawer front panel, both raised and

flat design, should be constructed in the same
manner as typical cabinet doors. 

• Order the custom drawer panel from the cabinet

manufacturer. Be sure to provide the exact
dimensions so that the panel is constructed
accurately.

• Order the optional custom handle to complement

or match surrounding cabinetry handles.

• Open the drawer fully.
• Turn the warming drawer off.

For installation of 27

″ and 30″ wide

warming drawer custom panel and
custom handle.

• Remove the two screws on each side and the

one screw at the bottom of the drawer edge.

• Remove the two screws on the inside of the

drawer at the top. Retain all screws.
– Support the drawer front as you remove

screws to prevent the possibility of falling.

• The custom panel must be sized to fit the

dimensions shown for your model.

• Drill a 5/16” diameter hole through the

appearance side of the panel. This hole will
allow the indicator “ON” light to be visible
through the custom panel. The cut edges will 
be covered by the overlap of the lamp jewel.
– A Brad point drill bit is recommended.

A

10-1/2"

1-13/16"

1-3/4"

Drill 5/16" Dia. 
Through Custom 
Panel For Lamp Jewel

A = 26-3/4” for 27” Wide Models
A = 30” for 30” Wide Models