Frigidaire FGRU19F6QF オーナーマニュアル

ページ / 24
13
Mid-Level Lighting Light Bulb Removal
To Remove Light Lens
Press Tabs
in Direction Shown
Mid Level Lighting
PURE ADVANTAGE™ Air Filter
Your new Pure Advantage air filter is located inside 
one of the 2-Liter Door Bins. The air filter cover is 
located on the upper right side of the control box.  
In general, you should change the air filter with 
Part Number “EAFCBF” every 6 months to ensure 
optimal filtering of freezer odors. The replacement 
air filter can be purchased on the Frigidaire website 
(http://frigidaire.stores.yahoo.net) or call toll free 
in the U.S. and Canada: 1-800-599-7569. Your 
electronic control is equipped with a Replace Air 
Filter indicator to remind you to change your filter.  
To Install Or Replace The Air Filter
•  Pull down on the front of the Pure 
Advantage™ air filter cover to release the 
hinged bottom cover.
•  Allow bottom cover to swing open and then 
remove the old filter and discard it.
•  Unpackage the new filter and place it inside 
the hinged bottom cover of the housing.
•  Push the hinged bottom cover upward until 
the tab snaps into closed position.
replace air filter
hold to reset
press & hold
air
filter
temp
mode
alarm
off
control
lock
 Open Air Filter Cover
Air Filter
Remove Air Filter
The mid level and upper level lighting comes on 
automatically when the door is opened. 
IMPORTANT
To disconnect power to the unit, unplug the 
unit or switch the breaker that supplies power 
to the unit to the off position. Replace the old 
bulb with a bulb of the same wattage.
To replace the light bulbs:
1. To replace the light bulb, turn the 
temperature control to OFF and unplug the 
electrical cord. 
2. Remove the lens from the lamp housing by 
unsnapping it from the lamp housing using 
your fingers or a screwdriver. Be careful not to 
break the locking tabs on the lamp housing. 
3. Replace the old bulb with a bulb of the same 
type and wattage. 
4. To replace the lens, snap one side of the 
lens opening to the tab on the lamp housing. 
Then carefully attach the other side. 
CHANGING THE FILTER 
INTERIOR LIGHTING