Friedrich WY09D33 インストール手順

CAUTION: Bodily injury can be caused by louvers

falling from a building during installation. It is

recommended that a safety line be attached

to the louver and to an anchor point inside the

building during installation.

4. Grasp the louver by the attached plastic handles.

Position it with the condensate drain knockouts fac-

ing down. From inside the building, maneuver the
louver through the wall sleeve and pull it toward you

until the screw heads are inserted into the keyhole
slots at the top of the wall sleeve. Tighten the two

screws completely.

5. Insert the remaining screws into the remaining holes

and tighten securely.

Installation

1. Remove the center support and weatherboard if still

installed in the sleeve.

2. Insert six plastic grommets into the louver openings

from the outside of the louver as shown in Figure 2.

3. Insert two #8 x 3/8” sheet metal screws (provided)

in the top two outside edge plastic grommets, and

tighten them half way into the grommets.

Parts List - Standard Louver
Description
Stamped Aluminum Louver

Plastic Grommets
#8 x 3/8" Sheet Metal Screws

Figure 1

Quantity

6
6

Figure 2

920-122-00 (3-07)

Grommet

Stamped

Louver

Knockout For

Drain Opening

Wall Sleeve

Plastic Handles

#8 x 3/8"

Sheet

Metal

Screw

Stamped

Louver

Installation Instructions

STANDARD LOUVER

For Use With Packaged Terminal Units

Please read these instructions completely before attempting installation.

NOTE: These instructions apply to the Packaged Terminal Unit Standard Louver Installation Kit ONLY. Refer to chassis

Installation/Operation manual and Wall Sleeve Installation Instructions for additional information.

Check box for parts listed in Figure 1.

Model PXGA