Frigidaire FFSC2323LP オーナーマニュアル

16

Your refrigerator’s water supply system includes 

several tubing lines, an advanced water filter,

a distribution valve bank, and a reserve tank 

to ensure ample supply to the ice and water 

dispenser at all times. This system needs to be 

completely filled with water when first connected

to an external supply line.

To prime the water supply system:
  1  Begin filling the tank by pressing and holding

a drinking glass against the water dispenser 

paddle.

  2  Keep the glass in this position until water 

comes out of the dispenser. It may take 

  3  Continue dispensing water for about four 

minutes to flush the system and plumbing

connections of any impurities (stopping to 

empty the glass as necessary).

The ice maker, ice bin, and dispenser feeding 

mechanism are located in the top of the freezer 

compartment. After the refrigerator is installed 

properly and has cooled for several hours, the ice 

maker can produce ice within 24 hours. It can 

completely fill an ice bin in about two days.



The water dispenser has a built-in device that 

shuts off the water flow after three minutes of

continuous use. To reset this shutoff device, 

simply release the dispenser paddle.

For proper dispenser operation, recommended 

water supply pressure should fall between 30 

psi and 100 psi. Excessive pressure may cause 

water filter to malfunction.

Your ice maker is shipped from the factory 

with the wire signal arm in the ON position 

(side mounted) or with the switch turned 

ON (rear mounted). To ensure proper 

function of your ice maker, hook up water 

supply immediately or turn ice maker OFF 

by lifting the wire signal arm until it clicks 

and locks in the UP position (side mounted) 

or turn the On/Off switch to the Off (0) 

position (rear mounted). If the ice maker 

make a loud chattering noise.

Before making ice for the first time, be sure

to prime the water supply system. Air in new 

plumbing lines can result in two or three empty 

ice maker cycles. Furthermore, if the system 

is not flushed, the first ice cubes may be

discolored or have an odd flavor.

Maker Produce in 24 Hours?
A side mounted ice maker will produce 4 to 4.5 

pounds of ice every 24 hours, depending on 

usage conditions. Ice is produced at a rate of 8 

cubes every 75 to 90 minutes.
How Much Ice Will a Rear Mounted Ice 

Maker Produce in 24 Hours?
A rear mounted ice maker will produce 3 to 4 

pounds of ice every 24 hours, depending on 

usage conditions. Ice is produced at a rate of 8 

cubes every 75 to 90 minutes.