Maytag MEDE500W オーナーマニュアル

You can change Sensor Cycles, Timed Cycles, Modifiers, and 

Options anytime before pressing START-PAUSE. 
NOTE: Three short tones sound if an unavailable combination is 

selected. The last selection will not be accepted.

1. Press START-PAUSE once. This pauses the current cycle.
2. Select the desired cycle and options.
3. Press and hold START-PAUSE. The dryer starts at the beginning of 

the new cycle.

NOTE: If you do not press START-PAUSE within 5 minutes of 

selecting the cycle, the dryer automatically shuts off.

You can change a Modifier or Option anytime before the selected 

Modifier or Option begins.
1. Press START-PAUSE once.
2. Select the new Modifier and/or Option.
3. Press and hold START-PAUSE to continue the cycle.

If all your loads on all Sensor cycles are consistently not as dry as 

you would like, you may change the preset Sensor Cycles Dryness 

settings to increase the dryness. This change will affect all of your 

Sensor cycles.
Your Sensor Cycles Dryness settings can be adjusted to adapt to 

different installations, environmental conditions or personal 

preference. There are 3 drying settings: 1 (factory preset dryness 

level), 2 (slightly dryer clothes, approximately 15% more drying 

time), and 3 (much dryer clothes, approximately 30% more drying 

time.) 
1. The Sensor Cycles Dryness settings cannot be changed while the 

dryer is running.

2. Press and hold the Sensor Cycles Dryness button for 5 seconds. 

The dryer will beep, and “CF” will be displayed on the Estimated 

Time Remaining screen for 1 second followed by the current 

drying setting.

3. To select a new drying setting, press the Sensor Cycles Dryness 

button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting 

will not flash, but the other settings will flash.

4. Press START-PAUSE to save the drying setting.
5. The drying setting you selected will become your new preset 

drying setting for all Sensor cycles.

The drying rack is useful for drying items you would not necessarily 

want to tumble dry or that you would normally line dry (for example, 

sweaters).
If your model does not have a drying rack, you may be able to 

purchase one for your model. To find out whether your model allows 

drying rack usage and for information on ordering, please refer to the 
front page of the manual or contact the dealer from whom you 

purchased your dryer. 
To use the drying rack
Do not remove the lint screen.
1. Open dryer door.

A

2. Place drying rack inside dryer drum, positioning the back wire 

on the ledge of the inner dryer back panel. Push down on front 

edge of drying rack to secure over the lint screen.

3. Put the wet items on top of the drying rack. Leave space between 

the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying rack. 

4. Close the door.
5. Select a timed drying cycle and temperature (see following 

chart). Items containing foam, rubber, or plastic must be dried on 

a clothesline or by using the Air Dry temperature setting.

6. You must select a time by pressing the TIME ADJUST up or down 

buttons. Reset time as needed to complete drying. Refer to the 

following table.

7. Press and hold START-PAUSE button (about 1 second).
NOTE: Check the lint screen and remove any lint accumulated from 

items dried on the drying rack.