Monogram ZV36SSFSS インストール手順

ページ / 16
11
Installation Instructions
STEP 2A  INSTALL HOOD ONTO WALL
• Secure the wood support to 2 or more vertical studs, using
at least 2 of the 4 supplied long screws.
IMPORTANT:
 Screws must penetrate at least 1-1/2" into
vertical studs. Countersink screws into support.
• Adjust depth of original mounting screws in the wood
support until they protrude 1/4" forward. This 1/4" gap will
provide clearance to hang the hood.
IMPORTANT: Framing must be capable of
supporting up to 150 lbs.
Test  Duct Cover Fit
• Place duct cover(s) over the top of the hood to check for gaps.
Adjust the hood up or down if necessary.
Install Bottom Mounting Screws
• Drill 1/8" pilot holes into the two lower mounting holes.
Enlarge the holes if they did not enter studs to 3/8". Insert
anchors for wall fasteners into bottom holes. Remove anchor
screws and add flat washers provided. Drive screws into anchors
and tighten.
• Install 4 additional screws through the back of the hood and
into the wood support.
IMPORTANT: Remove
shipping tape from
damper and check that
damper moves freely.
Duct
Transition
Top of
Hood
SKIP THIS STEP IF INSTALLING BENEATH A SOFFIT OR
CABINET, GO TO STEP 2B.
• Locate at least 2 vertical studs at the wood support.
• Center the supplied wood support, left to right and below the
15-3/8" marked line.
• Place the transition piece over the hood exhaust and secure
with 4 screws provided.
• Use duct tape to seal the connection. Check to be sure the
damper moves freely.
Hang Hood On Wood Support
• Lift the hood and hold close to the installation location.
Route house wiring through the knockout and into the
junction box.
• Place the hood over the wood support. Be sure the mounting
screws engage the keyhole slots in the back of the hood.
Tighten the screws.
WARNING: 
Continue to provide additional
support while the hood is mounted with only these 2 screws.
These screws will not support the weight of the hood. The hood
could fall resulting in damage or personal injury.
AVERTISSEMENT–
 Continuez à fournir un soutien
additionnel pendant le montage de la hotte avec ces deux vis seulement. Ces
deux vis ne soutiendront pas le poids de la hotte. La hotte peut tomber,
occasionnant des blessures corporelles ou des dommages matériels.
• Check to be sure the hood is level and centered.
Install Transition Onto Top of Hood
Centerline of 
Installation
Space
30"
to
36"
Centerline of 
Installation
Space
15-3/8"
30"
to
36"
Wood
Support
Note: The mounting
screws must remain in
their original shipping
location. These screws
are positioned to engage
the keyhole slots in the
back of the hood.
1/4"
Gap
Original Mounting
Screws as Shipped