Zephyr AHZM90AWX マニュアル

5. Replace the 6 wing nuts, 
tightening only the two at the 
front and leaving the other 4 
loose. Fig.4

6.  Close the door carefully un-
til it latches.

- Check for correct alignment:  
the side edges have to be aligned, and the distance between the top se-
cured glass and the lower glass should be approximately 1/16” across the 
whole width. Fig. 5

- If the glass is po-
sitioned correctly 
you may continue 
to step 9, otherwise 
please continue to 
the next stage.

7. Open the door 
again, then loosen 
the 2 front wing 
nuts and adjust the 
alignment by sli-
ding the glass.

8. Tighten the 2 front wing nuts and try closing the door again.

Please Note! If the alignment is still not correct, repeat the procedure 
from step 7.

9. Open the door and tighten the 4 remaining nuts. 

Now the glass has been fully secured to the hood.

min 1/16"

- 3 -