Monogram ZFSB25DXSS インストール手順

The refrigerator can be leveled by adjusting the rollers
located near the bottom hinges.

Rollers have three purposes:
• The rollers adjust so that the door closes easily when

opened about halfway. (Raise the front about 5/8" 
[16 mm] from the floor.)

• Rollers adjust to allow the refrigerator to be firmly

positioned on the floor and to prevent rocking 
when the doors are opened and closed.

• The rollers allow you to move the refrigerator from the

wall for cleaning.

Rollers

Raise

If the doors are not evenly aligned at the top, the
refrigerator door can be adjusted.
• Use a 7/16" hex socket or wrench to turn the door

adjusting screw. Turn the screw to the right to raise
the door, turn left to lower the door.

NOTE: A nylon plug is imbedded in the threads of 
the pin. The plug is designed to prevent the pin from
turning. A wrench must be used to turn the pin.

• Turn the wrench one or two times. Open and close the

refrigerator door to check alignment with the freezer
door at the top. Adjust again if necessary.

• Use a 3/8" hex socket or wrench to turn the 

adjustment screws. Turn the screws clockwise to raise
the refrigerator, turn counterclockwise to lower it.

Roller Adjusting Screw

Doors Should

Align at Top

Raise

Roller Adjusting Screws

• Use a 5/16" hex socket to turn the screws for the 

rear rollers. Turn the screws clockwise to raise the
refrigerator, counterclockwise to lower it.

Screw down the support leg until it touches the floor.
This will prevent door misalignment.