Smeg SC712U 使用とお手入れ

The oven may require special maintenance or replacement of parts subject to wear such as gaskets,
bulbs, etc. The following instructions describe how to perform these minor maintenance operations.

Remove the bulb protector A by twisting it counterclockwise and
then replace bulb B with an equivalent 25-W bulb. Replace bulb
protector A.

With the oven door completely open, raise the hinge
levers A until they touch the hinge arms B, then grasp
both sides of the door near the hinges. Raise the door
to an angle of about 45° and remove it. If the hinge
arms do not lock, repeat the operation, raising the
hinge levers and keeping the oven door slightly raised.
To remount the door, fit the hinges arm B into the hinge
slots, then lower the door into place, making sure that
the hinge arm notch C, is firmly seated in the slot, then
lower the hinge levers A.

Open the door completely and insert the pins (supplied) into the holes starting from the inside. Close the
door to an angle of about 45° and lift the door to remove it. To remount the door, fit the hinge arms into
the hinge slots, then lower the door into place and extract the pins. In case you lose the pins, two
screwdrivers can be used.