Gaggenau AL400721 インストール手順

ページ / 40
9
Installation Procedure
1
Before inserting the appliance into the cut-out of 
the worktop, remove the following transport locks:
‒ 2 plates on the front side of the appliance
‒ 2 fastening screws on the underside of the 
appliance
Plug holes on the underside of the device with 
the locking cap.
Note:  Keep the transport locks. Re-mount transport 
locks before transporting the appliance (e.g. during a 
move).
2
Push appliance from above into the cut-out of the 
countertop.
Note: Make sure that the seal on the underside of 
the cover does not slide.
3
Only for built-in installation: Before joining, make 
sure do perform a function test! 
Join surrounding 
gap with a suitable, temperature-resistant silicone 
glue (e.g. Novasil
®
, Pactan
®
). Smooth seal joint 
with a smoother recommended by the 
manufacturer. Heed the processing instructions 
for the silicone glue. Only start up the appliance 
after complete drying of the silicone glue (at least 
24 hours, depending on the room temperature).
NOTICE: 
Unsuitable silicone glue causes 
permanent discoloration with natural stone 
countertops.
4
Insert appliance evenly into the cut-out. Press 
firmly from above into the cut-out.
Notes
‒ The appliance must sit fast in the cut-out and 
may not slide (e.g. during cleaning). For cut-
out width on the upper tolerance limit, if 
necessary fasten ledges on the side in the cut-
out.
‒ Remove both plastic parts on the left and right 
of the cover.