Movincool CLASSICPLUS14 サービスマニュアル

Operation Section

28

• If the LCD indicates “PROGRAM ON”, press the COOL ON/OFF button to continue running the

program. If the LCD indicates “PROGRAM ON” continuously (program activated), no further

steps are necessary. If no program exists or the program was deactivated, press the FAN MODE

button or the COOL ON/OFF button. The unit returns to the previous temperature set point.

• The Classic Plus 14 model comes standard with a drain tank, which collect the water that forms

on the evaporator during normal cooling operation. If the unit is required to operate continuously

without periodic emptying of this tank, a condensate pump may be needed. A condensate pump

kit is available for the Classic Plus 14 model.

• The program within the microprocessor of the Classic Plus 14 contains a feature that

automatically restarts the unit after power is lost and then regained. The unit also has memory

in order to return itself back to the operating mode (either manual or preset program) it was in

prior to the loss of power. All preset programs are retained in the memory in the event power

loss occurs.

• There is a time delay program within the microprocessor. This prevents a heavy load from being

applied on the compressor motor when restarting the unit cool mode after a very short period of

time. This delay is in effect any time when the compressor is turned on by either the COOL

ON/OFF button, temperature set point (thermostatic control), power interruption restart or

condensate pump (optional) operation.

Time delay

- 120 ± 20 sec.

• The compressor operation cool mode is controlled by the microprocessor which receives input

signals from the room temperature thermistor (evaporator inlet air) and the setting of the

temperature set point. The temperature set point (desired room temperature) can be adjusted

by pressing the 

U/V buttons on the control panel. The adjustment range of the temperature set

point is 70 °F to 95 °F (21 °C to 35 °C).