Summit WMC64P サービスマニュアル
Service manual WM70.C
11
2 Settings
21 Water
inlet
inlet
Cold
Valid for products manufactured before February 2012.
Hot
21 HWC
Off (default)
Valid for products manufactured from February 2012.
On
22 Max RPM 400 rpm
This function only works for programmes Pr1-Pr19.
600 rpm
800 rpm
1000 rpm
800 rpm
1000 rpm
1200 rpm
1300 rpm
1400 rpm
1500 rpm
1600 rpm
1300 rpm
1400 rpm
1500 rpm
1600 rpm
23 Drain
Pump
Valve
Valve
24 Show
temp
temp
Temp Off
Only applies to the disinfection programmes (Pr17-Pr19)
Temp On
25 Change
temp
temp
Pr1-Pr25
This can be changed in steps of 1°C between -10°C to +10°C.
You cannot set a total temperature that exceeds +92°C.
You cannot set a total temperature that exceeds +92°C.
26 Programs Pr1-Pr28
Select “On” or “Off”
Programmes can be activated/deactivated. A deactivated
programme is not shown on the display.
programme is not shown on the display.
A maximum of 10 programmes can be shown on the display in
programme mode. If more than 10 programmes are activated,
then only the first ten activated programmes are shown on the
display.
programme mode. If more than 10 programmes are activated,
then only the first ten activated programmes are shown on the
display.
If all the programmes have been deactivated, the display only
shows “Pr1”.
shows “Pr1”.
If the machine is Swan-labelled, “Pr1” and “Pr2” are always
activated/On.
activated/On.
27 Spin time
0-300 sec
• Extend or shorten the spin time: 0-300 sec.
• If “0 sec” is selected, the pre-programmed spin time is used.
• If a time in the interval “1 sec” to “300 sec” is selected, this
time is added to the pre-programmed spin time.
• This function only works for programmes Pr13 and Pr14.
• If “0 sec” is selected, the pre-programmed spin time is used.
• If a time in the interval “1 sec” to “300 sec” is selected, this
time is added to the pre-programmed spin time.
• This function only works for programmes Pr13 and Pr14.
28 Coin
Coin Off
See the wiring diagram for the correct connection and
functionality of a slot meter.
functionality of a slot meter.
Coin On
29 Reset
Only
production
reset
production
reset
Used only in production
210
Off (default)
When On is choosed it shall be possible to temporally change
to language in the machine. The language shall return to selected
machine language (selected in the user menu) when the
program is finished. This menu step is placed after program 28.
to language in the machine. The language shall return to selected
machine language (selected in the user menu) when the
program is finished. This menu step is placed after program 28.
On
Return
Press the Key button (S5) to return to 2 Settings.
Service menu content (cont.)