Zephyr AK8800AS マニュアル

The custom hood liner must be installed before the power pack unit.  For installation into shallow 
cabinets (20-

1/2

” to 21-

1/2

“ inside depth) the power pack must be installed before the liner front 

panel section.  This must be done because the power pack flange must fit under the liner front 
panel section when an overlap occurs.

Refer to power pack instructions for mounting height details.

Install 1 small pad (A), included in the 
hardware package, to each side of the main 
liner plate.  (See figures 1 and 2)

Temporarily install the main liner plate (B) to 
the external base of the custom hood (C).  
When inserting the main liner plate, push 
slightly on the pads (A) to prevent damage.  
Main liner plate should be positioned as far 
back as possible.

Using a pen, mark the outline of the future 
opening for the power pack.  Remove the 
main liner plate (B) from the custom hood.

Cut out an opening in the bottom of the 
custom hood.

Reinstall the main liner plate to the base of 
the custom hood and secure it with (5) 3/4” 
screws.

Slide the front panel section (D) into the nose 
of the custom hood base.  Take care not to 
scratch the main liner plate when installing 
the front panel section of the liner.  Assemble 
it to the cabinet using (3) 1/2” screws.

www.zephyronline.com