Maytag MGR7685A インストール手順

1. Remove the oven racks.

2. Remove 2 screws at the rear of the oven bottom. 

3. Lift the rear of the oven bottom up and back until the front of 

the panel is away from the front frame. Remove from oven 
and set it aside on a covered surface.

4. Remove 2 screws from the front tabs of the flame spreader. 

Lift front of the flame spreader and pull forward to remove 
tabs from rear of oven and set it aside on a covered surface.

5. Remove 2 screws from the bake burner. 

6. Slide the front of the bake burner to the side to remove tab 

from front of oven. Lift the back of the bake burner off the 
oven orifice, and set the bake burner aside.

7. Use a 

³⁄₈" nut driver or combination wrench and turn the 

Natural gas bake burner orifice spud counterclockwise to 
remove. The spud will be stamped with a “49.”

8. Replace the “49” spud with a “57” spud. Install the LP gas 

bake burner orifice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.

9. Position the back of the bake burner over the oven orifice, 

and slide the tab on front of the bake burner into the front of 
the oven. 

10. Reattach the bake burner with 2 screws.

11. Insert the tabs on the rear of the flame spreader into the rear 

of the oven. 

12. Reattach the front tabs of the flame spreader to the oven with 

2 screws.

13. Position the front of the oven bottom panel toward the front 

frame and lower the rear of the oven bottom panel into the 
oven.

14. Reattach the oven bottom panel with 2 screws.

1. Remove the screw from the broil burner.

2. Remove the broil burner from the broil burner orifice hood.

NOTE: The broil burner will hang in the back of the oven while 
changing the orifice hood.

3. Use a 

³⁄₈" combination wrench and turn the Natural gas broil 

burner orifice hood counterclockwise to remove. The hood 
will be stamped with a “53.”

A

B

A

B

A

A

B

A

B

C

A