Frigidaire FFHB2740P オーナーマニュアル

10

To remove the refrigerator doors:
  1  Trace lightly around the door’s top hinges 

with a pencil. This makes reinstallation easier.

  2  Disconnect the harness by grasping both 

sides of the connector firmly, depress the

latch, and pull apart. Remove the two 

screws from the top hinge. Lift the door 

off of the bottom hinge and set it aside.

  3  Detach the water tube from the connector 

located behind the refrigerator and pull 

the tube back out to the front of the unit. 

The connector releases when you press 

inward on the outer sleeve while pushing 

the tube toward the connector then while 

continuing to hold in the sleeve, pull the 

tube away.

If your refrigerator will not fit through an

entrance area, you can remove the doors. 

Check first by measuring the entrance.
To prepare for removing the doors:
  1  Make sure the electrical power cord is 

unplugged from the wall outlet.

  2  Open the freezer drawer and remove the 

toe grille (see “Installation” section).

  3  Remove any food from the door shelves 

and close the doors.

To remove the top hinge covers:
  1  Remove the two screws from each cover 

over the top door hinges.

  2  Lift inside edge of hinge cover and tilt 

back.

Rear

Cover

Screw

Ground

Screw

Top

Hinge

Top Hinge

Cover

Hinge

Screws

Multi-wire

Cables

Leave

Hinge

With

Door

Front

Cover Screw

Water

Line

Rear

Cover

Screw

Front

Cover Screw

Top Hinge

Cover

Hinge

Screws

Two Wire

Cables

Leave

Hinge

With

Door

Top

Hinge

Ground

Screw



DO NOT remove the ground screw from hinge.



Use care while pulling the water tube from 

the unit to be sure that you do not kink the 

tube.