Frigidaire FFHB2740P オーナーマニュアル

Your ice maker is turned on at the factory so it 

can work as soon as you install your refrigerator. 

If you cannot connect a water supply, set the 

ice maker’s On/Off icon to Off and turn off the 

water supply valve; otherwise, the ice maker’s fill

valve may make a loud chattering noise when it 

attempts to operate without water.

On occasion, unusually small ice cubes may 

be noticed in the bucket or in dispensed ice. 

This could occur in normal operation of the 

ice maker. If you start seeing these more 

frequently, it may be an indication of low

water pressure or the water filter needs to be

replaced. As the water filter nears the end of its

useful life and becomes clogged with particles, 

less water is delivered to the ice maker during 

each cycle. Remember, if it’s been six months 

or longer since you last changed your water 

filter, replace the water filter with a new one.

Poor quality household water may require the

filter to be changed more frequently.

Turning off the ice maker will disable the ice 

dispenser. You will still be able to dispense water.

21



The water dispenser has a built-in device that 

shuts off the water flow after three minutes

of continuous use. To reset this shutoff 

device, simply release the dispenser paddle.



The ice maker also has a built-in plastic 

signal bale arm that automatically stops 

ice production when the ice bin is full. This 

signal arm should not be used to manually 

stop the ice maker.

For proper dispenser operation, recommended 

water supply pressure should fall between 

30 psi and 100 psi. Excessive pressure may 

cause water filter to malfunction.

 1  Begin filling the tank by pressing and holding

a drinking glass against the water dispenser 

paddle.

  2  Keep the glass 

in this position 

until water 

comes out of 

the dispenser. It 

may take about 

1½ minutes.

 3 Continue 

dispensing 

water for about 

four minutes to 

flush the system and plumbing connections

of any impurities (stopping to empty the 

glass as necessary).

After the refrigerator is installed properly and 

has cooled for several hours, the ice maker can 

produce ice within 24 hours. The ice maker will 

fill the ice bin from the rear. You must dispense

some ice to force the ice forward in the bin. This 

will allow the bin to fill completely.

Ice production is controlled by the ice maker’s 

On/Off icon on the control panel. Press and 

hold the “Ice Off” icon for three seconds to 

turn the ice maker “ON” or “OFF”. The ice 

maker is turned off when the LED above the 

“Ice Off” icon is illuminated.

Before making ice for the first time, be sure

to prime the water supply system. Air in new 

plumbing lines can result in two or three empty 

ice maker cycles. Furthermore, if the system 

is not flushed, the first ice cubes may be

discolored or have an odd flavor.



Dispensed water is chilled. For colder water, add 

ice to cup or container before dispensing water.