Viking PMF277TKSS インストール手順
@" Centerline to cutout 14-15/16" (379.71 mm)
@" Centerline to hole 14-5/16" (362.73 mm)
5/16" (8.77 mm)
FIGURE 1
Side Spacer (2 required)
Must protrude from edge of cabinet
cutout towards center as shown.
Must protrude from edge of cabinet
cutout towards center as shown.
(2) bottom spacers
24-5/8" width
1-5/8" height
FIGURE 2
Bottom Spacers (2 required).
FIGURE 3
Front of Cabinet
BUILT-IN TRIM KIT
FLUSH MOUNTING TEMPLATE
FOR CUSTOM SERIES MICROWAVE OVEN
5/16" (8.77 mm)
@" Cutout Opening Width 29-15/16" (759.42 mm)
CABINET CUTOUT LINE
FLOOR LINE OF CUTOUT OPENING
CENTER LINE
Cutout Opening Height 21-5/16" (542 mm)
1"
(25.4 mm)
UB4
1. Align the Flush Mounting Template center line with the center of the cabinet. Align
the Floor Line with the bottom of the cabinet at the desired height. Tape it in place.
2. Cut the cabinet opening along the three Cabinet Cutout Lines and the Floor Line.
3. Install two Side Spacers (see FIGURE 1) and two Bottom Spacers (see FIGURE 2) as
3. Install two Side Spacers (see FIGURE 1) and two Bottom Spacers (see FIGURE 2) as
specified in FIGURE 4.
4. Cut out the Side Spacer Templates (R and L) and align the indicated edge to the
corresponding Side Spacer (see FIGURE 3). Be careful to align the Floor Line to the
bottom edges of the Side Spacers.
bottom edges of the Side Spacers.
5. Predrill two holes indicated “A“ in Side Spacer - R with a 1/16" drill bit.
6. Predrill two holes indicated ”B“ in Side Spacer - L with a 1/16" drill bit.
7. Remove template from the cabinet.
6. Predrill two holes indicated ”B“ in Side Spacer - L with a 1/16" drill bit.
7. Remove template from the cabinet.
The exhaust duct should be aligned with the front of the bottom spacer closest to the
cabinet opening. The exhaust duct should align left to right with the left and right
edges of the bottom spacers. The exhaust duct should be secured to the bottom spacer
with Screw (C).
cabinet opening. The exhaust duct should align left to right with the left and right
edges of the bottom spacers. The exhaust duct should be secured to the bottom spacer
with Screw (C).
1-15/16" (50.35 mm)
1-15/16" (49.9 mm)
22-1/16" (561.0 mm)
24-5/8" (625.5 mm)
4"
4"
(1) Bottom Spacer
(2) Bottom Spacer
TOP VIEW
12-1/8" (308.45 mm)
FIGURE 4
Bottom Spacers centered with cabinet cutout
Edges to align Side Spacer Templates (R and L)
Side Spacer -
L
Side Spacer -
R
H
eigh
t D
istanc
e B
et
w
een H
oles
A
15-3/4" (399.63 mm)
2-13/16"
(71.1 mm)
CABINET CUTOUT LINE
=" Centerline to hole 12-13/16" (324.63 mm)
=" Centerline to cutout 13-7/16" (341.6 mm)
=" Cutout Opening Width 26-15/16" (683.2 mm)
TINSKB145MRR0