Vapamore MR50 マニュアル

TROUBLESHOOTING GUIDE

1. Connect power cord to a known good wall outlet.

2. Slide power switch to the vacuum mode.

3. Check power cord for any damage. (If damaged do not operate, have
cord replaced by a qualified technician).

4. Empty the dust collection reservoir and remove any blockage in the
dust tank mouth.

5. Clean or replace the dust filter.

WET - DRY VACUUM

1. Connect power cord to a known good wall outlet.

2. Make sure water tank is filled.

3. Check power cord for any damage. (If damaged do not operate, have
cord replaced by a qualified technician).

4. Slide power switch to the dry steam or wet steam mode.

5. Clean steam outlet with supplied tool. (Make sure the MR-50
Steam - Vac is unplugged from outlet during cleaning)

6. Wait 20 seconds for steam to be produced.

DRY STEAM / WET STEAM

CLEANING THE MR-50 STEAM VAC

1.To remove the dust collection reservoir by releasing the locking tab
located on the underside and between the easy glide wheels.

2. Always have the MR-50 Steam - Vac nozzle facing the ground when
removing the dust collection reservoir.

3. Rinse the washable dust filter and dust collection reservoir under
running hot water. Allow dust filter to dry completely before use.

DUST COLLECTION RESERVOIR

(Make sure the MR-50 Steam - Vac is unplugged from outlet)

STEAM OUTLET

Clean the steam outlet hole using the supplied tool to remove any mineral
deposits or build up. The steam outlet hole is located on the underside
and between the easy glide wheels.

A. Rubber Gaskets x 2
B. Dust collection Filter
C. Plastic Dust Filter Adapter
D. Dust collection Reservoir