Electrolux EI30BM60MS インストール手順

Attach Mounting Plate to Wall

Prepare Top Cabinet 

Mount the Microwave Oven

Make sure the screws for the blower motor and blower
plate are securely tightened when they are reinstalled.
This will help to prevent excessive vibration.

Make sure the motor wiring has been properly routed
and secured, and that the wires are not pinched.

Read the instructions on the TOP CABINET
TEMPLATE.

Tape it underneath the top cabinet.

Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.

Wear safety goggles when drilling holes

in the cabinet bottom.

You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.

Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall 
to mount the plate.

Before tightening toggle bolts and wood

screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: 

Be careful to avoid pinching fingers

between the back of the mounting plate and the wall.

Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.

Attach the plate to the wall using toggle bolts. 
At least one wood screw must be used to attach 
the plate to a wall stud.

Remove the toggle wings from the bolts. 

Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to 

3

⁄

4

″ (19 mm) onto

each bolt. 

Wall

Mounting

Plate

Spacing for Toggles
More Than Wall
Thickness

Bolt End

Toggle 
Bolt

Toggle Wings

Install or change Charcoal Filter

Check Blower Plate

NOTE: IT IS VERY IMPOR

TANT TO

READ AND FOLLOW THE 

DIRECTIONS

IN THE INSTALLATION IN

STRUCTIONS

BEFORE PROCEEDING WIT

H THIS

REAR WALL TEMPLATE.
This Rear Wall Template serv

es to position the bottom 

mounting plate and to locate 

the horizontal exhaust 

outlet. 

1. Use a level to check that th

e template is positioned 

    accurately. 

2. Locate and mark at least o

ne stud on the left or 

    right side of the centerline.

It is important to use at leas

t one wood 

screw mounted firmly in a stu

d to support the weight 

of the microwave. Mark two a

dditional, evenly spaced 

locations for the supplied tog

gle bolts. 

3. Drill holes in the marked lo

cations. Where there is 

    a stud, drill a 3/16" hole for

 wood screws. For holes 

    that do not line up with a s

tud, drill 5/8" holes for 

    toggle bolts. 

DO NOT INSTALL THE M

OUNTING PLATE

AT THIS TIME. 

4. Remove the template from

 the rear wall. 

5. Review the Installation Ins

truction book for your 

    installation situation. 

Locate and mark holes to al

ign with holes in the 

mounting plate. 
IMPORTANT: 
LOCATE AT LEAST ONE 

STUD ON EITHER SIDE O

F 

THE CENTERLINE. 
MARK THE LOCATION FO

R 2 ADDITIONAL, EVENL

Y 

SPACED TOGGLE BOLTS

 IN THE MOUNTING PLATE

AREA.

Locate and mark holes to 

align with holes in the 

mounting plate. 
IMPORTANT: 
LOCATE AT LEAST ONE 

STUD ON EITHER SIDE O

F 

THE CENTERLINE. 
MARK THE LOCATION FO

R 2 ADDITIONAL, EVENL

Y 

SPACED TOGGLE BOLTS

 IN THE MOUNTING PLATE

AREA.

20