Whirlpool W10413645A インストール手順

Water Filter Installation Instructions

Follow these simple instructions for your filter type.

Refrigerator Water Filter 2

1. Locate the filter door in the right side of the refrigerator ceiling.

2. Press in up on the filter cover door to release the door latch. The door will

drop down.

3. If you are replacing a filter rotation the used filter counter clockwise to

remove it from the filter head. Note: there may be some water in the filter

and some spilling may occur.

4. Take the new water filter out of the packaging and remove the cap. Be sure

the O-rings are still in place after the cover is removed.

5. Align the arrow on the water filter label with the cutout notch in the filter head

and insert the filter.

6. Turn the filter clockwise until it locks into the housing.

7. Lift the filter up into the compartment. Close the filter door completely.

8. Reduce water spurts by flushing air from the system. Run water continuously

for 4 gallons (approximately 5 minutes) through the dispenser until water

runs steady. Additional flushing may be required in some households where

water is of poor quality.

Part W10413645A

Phone:

US: 1-866-698-2538

Hours of operation:

Monday – Friday 8:00 AM – 8:00 PM EST