Maytag MEDC215EW-WW ユーザーズマニュアル

A

E

B

Remove center terminal block screw (B). Remove neutral ground 

wire (E) from external ground conductor screw (A).

B

C

E

Connect neutral ground wire (E) and neutral wire (white or 

center wire) (C) of power supply cord or cable under center 

terminal block screw (B). Tighten screw.

Place hooked ends of remaining wires under outer terminal 

block screws (hooks facing right). Tighten screws. 

A

G

Connect a separate copper ground wire (G) from the external 

ground conductor screw (A) to an adequate ground. Finally, 

reinsert tab of terminal block cover into slot of dryer rear 

panel. Secure cover with hold-down screw. Now, go to Venting 

Requirements. 

Place hooked ends of remaining direct wire cable wires  under 

outer terminal block screws (hooks facing right). Squeeze hooked 

ends together and tighten screws. Finally, reinsert tab of terminal 

block cover into slot of dryer rear panel. Secure cover with hold-

down screw. Now, go to Venting Requirements.

C

B

Place hooked end of neutral wire (white or center) (C) of direct 

wire cable under center terminal block screw (B). Squeeze 

hooked end together. Tighten screw.