Frigidaire FGHS2355PF オーナーマニュアル

21

Do not use with water that is microbiologically 

unsafe or of unknown quality without adequate

disinfection before or after the system. 

Systems certified for cyst reduction may be

used on disinfected waters that may contain 

filterable cysts.

•  Rated Capacity - 200 gallons/757 liters for 

ice and water filter

•  Rated service flow - .50 gallons per minute
•  Operating Temp.: Min. 33°F,  Max. 100°F
•  Maximum Rated Pressure - 100 pounds per 

square inch

•  Recommended Minimum Operating 

Pressure: 30 pounds per square inch

It is not necessary to turn the water supply off 

to change the filter. Be ready to wipe up any

small amounts of water released during the 

filter replacement.
  1  Turn Off the ice maker.
  2  Remove the filter by pushing on the end/

face of the filter.

  3  Slide the old water filter cartridge straight

out of the housing and discard it.

  4  Unpackage the new filter cartridge. Using

the alignment guide, slide it gently into 

the filter housing until it stops against

the snap-in connector at the back of the 

housing.

  5  Push firmly until the cartridge snaps into

place (you should hear a click as the 

cartridge engages the snap-in connector).

  6  Press a drinking glass against the water 

dispenser while checking for any leaks at 

the filter housing. Any spurts and sputters

that occur as the system purges air out of 

the dispenser system are normal.

The PureSource Ultra

 ice 

and water filter system is tested

and certified to NSF/ANSI

Standards 42 and 53 for the 

reduction of claims specified on

the performance data sheet.

  7  After filling one glass of water, continue

flushing the system for about four

minutes.

  8  Turn On the ice maker.
  9  Press and hold the Water Filter button 

on the Ice & Water Dispenser control 

panel for three seconds. When the display 

changes from “Red” to “Green,” the status 

has been reset.