Frigidaire FFHS2622MB オーナーマニュアル

6



The refrigerator doors are designed to shut by 

themselves within a 20 degree opening.

Your refrigerator should be positioned to allow easy 

access to a counter or table when removing food. For 

best use of drawers and freezer baskets, the refrigerator 

should be in a position where both the refrigerator and 

freezer doors can be fully opened.

 •  All four corners of the cabinet must rest firmly on

the floor.

 •  The cabinet should be level at the front and rear.
 •  The sides should tilt ¼ inch (6 mm) from front to

back (to ensure that doors close and seal properly).

 •  Doors should align with each other and be level.

To level the cabinet using the front rollers:
  1  Open both doors and remove the toe grille (see 

“Toe Grille Installation and removal” in the 

“Installation” section).

  2  Close the doors and use a flat-blade screwdriver or

3

/

8

  inch socket wrench to raise or lower the front 

rollers.

  3  Ensure both doors are bind-free with their seals 

touching the cabinet on all four sides.

Hinge
Flange

Set Screw
(some models)

Door Stop
Flange

Hinge

Open Door

7/16” Wrench

and 3/32” Hex Key

(some models)

  6  Replace the toe grille by fitting it into place

(see “Toe Grille Installation and Removal” in the 

“Installation” section).

  4  After leveling, verify door stop contacts lower hinge 

and top of door does not contact upper hinge 

through full movement of door (from fully closed to 

fully open).

  5  Reinstall set screw, locking the door height.



Some models will not have a set screw. For those 

models follow steps 2 through 4.

  1  Before leveling either door, remove set screw that 

locks door height into position.  (The door cannot 

be adjusted without set screw removed).

  2  If the refrigerator door is lower than the freezer 

door, raise the refrigerator door by turning the 

adjustment screw clockwise using a 

7

/

16  

inch 

wrench. (See illustration.)

  3  If the freezer door is lower than the refrigerator 

door, raise the freezer door by turning the 

adjustment screw clockwise using a 

7

/

16  

inch 

wrench. (See illustration.)