Electrolux EI32AR80QS オーナーマニュアル

7

1.  Remove handle from carton and any 

other protective packaging.

2.  Position refrigerator handle end caps 

over upper and lower pre-installed 

shoulder bolts (A) that are fastened 

into door, ensuring the holes for 

the set screws are facing towards 

the outside of door if a single unit 

installation or the freezer door (if 

installing the matching freezer)

3.  While holding handle firmly against 

door, fasten upper and lower Allen set 

screws (B) with supplied Allen wrench.

4.  Repeat steps 2 and 3 to install 

freezer handle (if installing the 

matching freezer). Ensure the holes 

for the set screws are facing towards 

the freezer door.

NOTE

All set screws should be tightened and 

sub-flush (Allen set screw should be seated 

just below the surface of the end cap) of 

handle end cap. The end caps should be 

drawn tight to door with no gaps.

To remove the toe grille, use a Phillips 

head screwdriver and remove the two 

screws holding the toe grille to the cabinet. 

Then pull the toe grille away from the unit.

•  The refrigerator must have all bottom 

corners resting firmly on a solid floor.

•  The floor must be strong enough to 

support a fully loaded refrigerator.

•  It is 

VERY IMPORTANT for your 

refrigerator to be level in order to 

function properly. If the refrigerator 

is not leveled during installation, 

the door may be misaligned and 

not close or seal properly, causing 

cooling, frost or moisture problems.

A

B

Single Unit Installation

Ensure handle set screws

are facing each other

with doors closed

Matching Refrigerator and Freezer Door 

Handle Installation

Remove 

Screws

Toe Grille