Frigidaire FFSS2614QE オーナーマニュアル

ページ / 30
IMPORTANT
Your ice maker is shipped from the factory 
with the wire signal arm in the ON position 
(side mounted) or with the switch turned ON 
(rear mounted). To ensure proper function 
of your ice maker, hook up water supply 
immediately or turn ice maker OFF by lifting 
the wire signal arm until it clicks and locks in 
the UP position (side mounted) or turn the 
On/Off switch to the Off (0) position (rear 
mounted). If the ice maker is not turned off 
and the water supply is not connected, the 
water valve will make a loud chattering noise.
20
AUTOMATIC ICE & WATER DISPENSER
Priming the Water Supply System
Your refrigerator’s water supply system includes 
several tubing lines, an advanced water filter,
a distribution valve bank, and a reserve tank 
to ensure ample supply to the ice and water 
dispenser at all times. This system needs to 
be completely filled with water when first
connected to an external supply line.
To prime the water supply system:
  1  Begin filling the tank by pressing and
holding a drinking glass against the water 
dispenser paddle.
  2  Keep the glass in this position until water 
comes out of the dispenser. It may take 
about 1½ minutes.
  3  Continue dispensing water for about four 
minutes to flush the system and plumbing
connections of any impurities (stopping to 
empty the glass as necessary).
Ice Maker Operation & Care
The ice maker, ice bin, and dispenser feeding 
mechanism are located in the top of the freezer 
compartment. After the refrigerator is installed 
properly and has cooled for several hours, the 
ice maker can produce ice within 24 hours. It 
can completely fill an ice bin in about two days.
Using the Ice Maker after 
Installation
Before making ice for the first time, be sure
to prime the water supply system. Air in new 
plumbing lines can result in two or three empty 
ice maker cycles. Furthermore, if the system 
is not flushed, the first ice cubes may be
discolored or have an odd flavor.
NOTE
The water dispenser has a built-in device that 
shuts off the water flow after three minutes
of continuous use. To reset this shutoff 
device, simply release the dispenser paddle.
CAUTION
For proper dispenser operation, recommended 
water supply pressure should fall between 30 
psi and 100 psi. Excessive pressure may cause 
water filter to malfunction.
Ice Production: What to Expect
How Much Ice Will a Side Mounted Ice 
Maker Produce in 24 Hours?
A side mounted ice maker will produce 4 to 4.5 
pounds of ice every 24 hours, depending on 
usage conditions. Ice is produced at a rate of 8 
cubes every 75 to 90 minutes.
How Much Ice Will a Rear Mounted Ice 
Maker Produce in 24 Hours?
A rear mounted ice maker will produce 3 to 4 
pounds of ice every 24 hours, depending on 
usage conditions. Ice is produced at a rate of 8 
cubes every 75 to 90 minutes.