Frigidaire FFHB2740PS オーナーマニュアル

17

After connecting the water supply, refer to 

“How to Prime the Water Supply System” for 

important information about priming an empty 

water supply system.
Your refrigerator’s water supply system 

includes several tubing lines, a water filter,

a water valve, and a water tank. To ensure 

that your water dispenser works properly, this 

system must be completely filled with water

when your refrigerator is first connected to

the household water supply line.

Steel

Clamp

Brass

Compression

Nut

Water Line

Water Valve

Bracket

Valve Inlet

Water Valve

Water line from household

water supply

(Include enough tubing in loop to allow

moving refrigerator out for cleaning.)

Ferrule

(Sleeve)

Plastic Water Tubing

to Ice Maker

Fill Tube

  1  Disconnect refrigerator from electric power 

source.

  2  Place end of water supply line into sink or 

bucket. Turn ON water supply and flush

supply line until water is clear. Turn OFF 

water supply at shutoff valve.

  3  Remove plastic cap from water valve inlet 

and discard cap.

  4  If you use copper tubing - Slide brass 

compression nut, then ferrule (sleeve) 

onto water supply line. Push water supply 

line into water valve inlet as far as it 

will go (¼ inch/6.4 mm). Slide ferrule 

(sleeve) into valve inlet and finger tighten

compression nut onto valve. Tighten 

another half turn with a wrench; DO NOT 

over tighten. See Figure 1.

    If you use stainless steel tubing - The 

nut and ferrule are already assembled on 

the tubing. Slide compression nut onto 

valve inlet and finger tighten compression

nut onto valve. Tighten another half turn 

with a wrench; DO NOT over tighten. See 

Figure 1.

  5  With steel clamp and screw, secure water 

supply line (copper tubing only) to rear 

panel of refrigerator as shown.

  6  Coil excess water supply line (copper 

tubing only), about 2½ turns, behind 

refrigerator as shown and arrange coils so 

they do not vibrate or wear against any 

other surface. Do not kink tubing.

  7  Turn ON water supply at shutoff valve and 

tighten any connections that leak.

  8  Reconnect refrigerator to electrical power 

source.

  9  To turn ice maker on, lower wire signal 

arm (freezer ice maker) or set the ice 

maker’s On/Off power switch to the “On” 

position (fresh food ice maker).