Yamaha ysp-1600bl オーナーマニュアル
PREPARATIONS
➤ f Initial settings
En
21
1
Turn on the unit, TV, and playback devices.
2
Activate the HDMI control function on the unit, TV,
and playback devices such as BD/DVD players that
support this function.
and playback devices such as BD/DVD players that
support this function.
For this unit, be sure that “HDMI Control” is set to “On”
(default; p. 51).
(default; p. 51).
For playback devices, refer to the instructions supplied with
each device.
each device.
3
Turn off the main power of the TV and then turn off
the unit and playback devices.
the unit and playback devices.
4
Turn on the unit and playback devices and then turn
on the TV.
on the TV.
5
Switch the TV input to display the video from the
unit.
unit.
6
Press the HDMI key to select HDMI input, and check
that video from the playback device is properly
displayed.
that video from the playback device is properly
displayed.
7
Check that the unit is properly coordinated with the
TV by turning off the TV or adjusting the TV volume
with the TV remote control.
TV by turning off the TV or adjusting the TV volume
with the TV remote control.
When the connected devices and jacks are changed, configure the
settings again with the following procedure.
settings again with the following procedure.
1
Disable the HDMI control function of the TV and BD/
DVD player, turn off all connected devices, and
change the connections.
DVD player, turn off all connected devices, and
change the connections.
2
Follow steps 1 to 7 of “Setting the HDMI control
function”.
function”.
Setting the HDMI control function
HDMI
Glows (green)
If devices are not coordinated
Be sure that all devices are correctly connected to this unit, and
that settings are properly configured as described below.
that settings are properly configured as described below.
– “HDMI Control” (p. 51) is set to “On” in the setup menu.
– The HDMI control function is enabled on the TV.
The example of TV settings
• From the setup menu on your TV, select “Link setting”
“HDMI control setting”, then set a setting such as “HDMI
control function” to “ON”.
control function” to “ON”.
• Set audio output to any option other than TV.
If devices fail to coordinate even after the settings described
above have been applied correctly:
above have been applied correctly:
– Turn off this unit and the TV, and then turn them back on again.
– Disconnect the power cable of the unit and external devices
connected to the unit via HDMI cable. Plug them in again after
about 30 seconds.
about 30 seconds.
– If devices fail to coordinate after ANALOG is input, repeat
steps 5 and 6 under “Setting the HDMI control function”.
Changing the connection method and
connected devices
connected devices
1 2 3 4 5 6
HDMI