Yamaha YAS-103 オーナーマニュアル

ページ / 24
5
En
Installation
Place the sound bar on a flat surface such as on top of a 
TV cabinet.
Removing the stands
When the sound bar blocks the view of the lower part of the 
TV screen or the remote control sensor of the TV, remove the 
stands (18 mm [3/4"]) of the sound bar to adjust its height.
HINT
• Use the TV Remote Repeater function (p.14) to transmit TV’s 
remote control signals via the sound bar.
NOTE
• Keep the stands and screws in a safe place for future use.
Attaching the sound bar to a wall
How to install on the wall
1 Attach the mounting template on a wall and mark 
for the screw holes.
2 Remove the mounting template from the wall, 
then install commercially available screws and 
supplied spacers (as illustrated below) at the 
points marked on the wall.
3 Hang the sound bar on the screws.
Cautions
• Do not place the sound bar on/under any other devices such as 
BD player in a pile. Doing so may cause a malfunction due to 
vibrations.
• Do not touch the grilles (fabric parts) on the front of the sound 
bar.
• The sound bar contains acoustic suspension speakers. Do not 
place magnetically sensitive items (hard disk drive, etc.) near the 
sound bar.
• Depending on your installation environment, it may be better to 
connect the sound bar and external devices (such as a TV) 
before installing the sound bar.
• Do not place the sound bar within 50 mm (2") of the TV. The wall 
mount brackets on the rear panel can be removed as necessary.
Cautions
• When installing the sound bar on a wall, all installation work must be 
performed by a qualified contractor or dealer. The customer must never 
attempt to perform this installation work. Improper or inadequate 
installation could cause the sound bar to fall, resulting in personal injury.
• Do not attach the sound bar to a wall that is made of weak 
materials such as plaster or veneered woods. Doing so may 
cause the sound bar to fall.
• Make sure you use commercially available screws that can 
support the weight of the installation (specified in Step 2 on the 
right). Using clamps other than specified screws, such as short 
screws, nails, and two-sided tape, may cause the sound bar to fall.
Cautions
• Fix the cables in place where they will not become loose. If your 
foot or hand accidentally gets caught on a loose cable, the sound 
bar may fall.
• Check that the sound bar is fixed securely after the installation. 
Yamaha will bear no responsibility for any accidents caused by 
improper installations.
Tapes or thumbtacks
Mounting template (supplied)
Screw 
holes
7 to 9 mm
(1/4" to 3/8")
2 to 4 mm (1/16" to 3/16")
4 mm (#8)
20 mm (3/4") 
or more
Spacer (supplied)
Mounting holes 
on rear of sound bar