Maytag MET8720DS インストール手順

Use this method for:

■

New branch-circuit installations (1996 NEC)

■

Mobile homes 

■

Recreational vehicles

■

In an area where local codes prohibit grounding through the 
neutral

1. Part of metal ground strap must be cut out and removed.

2. Use Phillips screwdriver to remove the ground-link screw from 

the back of the range. Save the ground-link screw and the end 
of the ground link under the screw.

3. Feed the power supply cord through the strain relief in the cord/

conduit plate on bottom of range. Allow enough slack to easily 
attach the wiring to the terminal block.

4. Use Phillips screwdriver to connect the green ground wire from 

the power supply cord to the range with the ground-link screw. 
The ground wire must be attached first.

5. Use 

³⁄₈" nut driver to connect the neutral (white) wire to the 

center terminal block post with one of the 10–32 hex nuts.

6. Connect line 1 (black) and line 2 (red) wires to the outer terminal 

block posts with 10-32 hex nuts.

7. Securely tighten hex nuts.

NOTE: For power supply cord replacement, only use a power 
cord rated at 250 volts minimum, 40 amps or 50 amps that is 
marked for use with nominal 1

³⁄₈" (3.5 cm) diameter connection 

opening, with ring terminals and marked for use with ranges.

8. Replace terminal block access cover.

Use this method only if local codes permit connecting chassis 
ground conductor to neutral wire of power supply cord.
1. Feed the power supply cord through the strain relief in the cord/

conduit plate on bottom of range. Allow enough slack to easily 
attach the wiring to the terminal block.

A

B

C

A

B

C

D

A

B

C

F

D

E

A

C

B

D