Frigidaire FASE7073NW インストール手順

9

  1  Installation MUST conform to current Manufactured 

Home Construction & Safety Standard, Title 24 

CFR, Part 32-80 (formerly the Federal Standard 

for Mobile Home Construction and Safety, Title 24, 

HUD Part 280) or Standard CAN/CSAZ240 MH.

  2  Dryer MUST be exhausted outside (outdoors, not 

beneath the mobile home) using metal ducting 

that will not support combustion. Metal ducting 

must be 4 inches (10.16 cm) in diameter with no 

obstructions. Rigid metal duct is preferred.

  3  If dryer is exhausted through the fl oor and area 

beneath the mobile home is enclosed, the exhaust 

system MUST terminate outside the enclosure with 

the termination securely fastened to the mobile 

home structure.

  4  Refer to previous sections in this guide for other 

important exhaust venting system requirements.

  5  When installing a gas dryer into a mobile home, a 

provision must be made for outside make up air. 

This provision is to be not less than twice the area 

of the dryer exhaust outlet.

  6  Installer MUST anchor this (1) dryer or (2) dryer 

mounted on pedestal to the fl oor with approved 

Mobile Home Installation Kit - P/N 137067200.

DO NOT INSTALL YOUR DRYER:
  1  In an area exposed to dripping water or outside 

weather conditions.

  2  In an area where it will come in contact with 

curtains, drapes, or anything that will obstruct 

the fl ow of combustion and ventilation air.

  3  On carpet. Floor MUST be solid with a maximum 

slope of 1 inch (2.54 cm).

Do not install the dryer where gasoline or other 

fl ammables are kept or stored. If the dryer is installed 

in a garage, it must be a minimum of 18 inches (45.7 

cm) above the fl oor. Failure to do so can result in 

death, explosion, fi re or burns.