Frigidaire FFSS2314QE オーナーマニュアル

11

After connecting the water supply, refer to 

“How to Prime the Water Supply System” 

for important information about priming an 

empty water supply system.
Your refrigerator’s water supply system 

includes several tubing lines, a water filter,

a water valve, and a water tank. To ensure 

that your water dispenser works properly, 

this system must be completely filled

with water when your refrigerator is first

connected to the household water supply 

line.

Steel

Clamp

Stainless

Steel

water line

Water Valve

Bracket

Valve Inlet

Water Valve

Plastic Water Tubing

to Ice Maker

Fill Tube

6 ft. Stainless Steel water line from

household water supply

Plastic Water

Tubing to Ice

Maker Fill

Tube

Steel

Clamp

Brass

Compression

Nut

Ferrule

(Sleeve)

Copper

water line

Water Valve

Bracket

Valve Inlet

Water Valve

Copper water line

from household

water supply

(Include enough tubing in loop

to allow moving refrigerator out

for cleaning.)

  5  With steel clamp and screw, secure water 

supply line (copper tubing only) to rear 

panel of refrigerator as shown.

  6  Coil excess water supply line (copper 

tubing only), about 2½ turns, behind 
refrigerator as shown and arrange coils so 
they do not vibrate or wear against any 
other surface.

  7  Turn ON water supply at shutoff valve and 

tighten any connections that leak.

  8  Reconnect refrigerator to electrical power 

source.

  9  To turn ice maker on, lower wire signal 

arm (side mounted) or set the ice maker’s 
On/Off power switch to the “I” position 
(rear mounted).