Lorex LNC226X オーナーマニュアル
DRAFT
8. Place your device about 1ft (30cm) away from the camera.
The camera scans the QR code on your iPad® to connect to the WiFi network. When
the connection is successful, the camera beeps, and the “Camera Found” message
below appears on your device after a few seconds.
the connection is successful, the camera beeps, and the “Camera Found” message
below appears on your device after a few seconds.
Note
LNC226X does not have a speaker, and therefore, will not beep when the connection is successful.
Check for the “Camera Found” message below on your device to confirm that connection was
successful.
Check for the “Camera Found” message below on your device to confirm that connection was
successful.
9. Enter a name for your camera and press OK.
10. Tap the camera to connect.
11. If this is the first time connecting to the camera, you will be prompted to create your
11. If this is the first time connecting to the camera, you will be prompted to create your
own password. Tap OK.
#LX400003; r. 1.0/12783/13451; en-US
26