Lorex LNC226X オーナーマニュアル
DRAFT
2
3
4
5
6
7
To configure image quality settings:
1. Right-click on the camera in Camera List and select Video settings. Select the Qual-
ity tab.
2. Under Bandwidth, select the speed of your Internet connection. If your Internet con-
nection is faster than 3Mbps, select 3Mbps.
3. Check Select the best resolution and frame rate automatically to have the camera
automatically adjust the resolution and frame rate based on bandwidth. If you set the
resolution to adjust automatically, go straight to step 6. Or, un-check it to manually con-
figure the resolution (step 4) and frame rate (step 5).
resolution to adjust automatically, go straight to step 6. Or, un-check it to manually con-
figure the resolution (step 4) and frame rate (step 5).
4. Resolution: Manually select either (640x480) VGA, (320x240) QVGA, 1024x768, or
1280x800 resolution. Higher resolution settings will give you a better, more detailed
picture, but requires more bandwidth. QVGA allows the camera to maintain a higher
frame rate when available bandwidth is low.
picture, but requires more bandwidth. QVGA allows the camera to maintain a higher
frame rate when available bandwidth is low.
5. Frame rate: Manually select the frame rate between 30fps (highest) and 1fps (low-
est). 30fps is real time video, meaning that movement in the image will appear smooth,
with no choppiness.
with no choppiness.
6. Under Preference, select your quality preference when bandwidth increases or
decreases:
• Select Video motion to have the camera maintain the frame rate and reduce image
quality when bandwidth is insufficient.
• Select Image quality to have the camera maintain image quality and reduce frame
rate when bandwidth is insufficient.
• Select Better quality to have the camera maintain frame rate and increase quality
when bandwidth is sufficient.
• Select Best quality to have the camera maintain the frame rate and increase qual-
ity to the maximum speed of the connection.
7. Click Update to save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. Click OK to close the settings window.
Note
The camera may reboot after settings are changed. Wait about 30 seconds and then double-click
the camera in Camera List or Auto Search to reconnect to the camera.
The camera may reboot after settings are changed. Wait about 30 seconds and then double-click
the camera in Camera List or Auto Search to reconnect to the camera.
#LX400003; r. 1.0/12783/13451; en-US
84