Pro-Form PFTL39115 ユーザーズマニュアル

MAINTENANCE

Regular maintenance is important for optimal per-

formance and to reduce wear. Inspect and properly

tighten all parts each time the treadmill is used.

Regularly clean the treadmill and keep the walking

belt clean and dry. First, press the power switch into

the off position and unplug the power cord. Wipe

exterior parts of the treadmill with a damp cloth and

a small amount of mild soap. IMPORTANT: Do not

spray liquids directly onto the treadmill. To avoid

damage to the console, keep liquids away from the

console. Then, thoroughly dry the treadmill with a soft

towel.

TROUBLESHOOTING

Most treadmill problems can be solved by follow-

ing the simple steps below. Find the symptom that

applies, and follow the steps listed. If further assis-

tance is needed, see the front cover of this manual.

SYMPTOM: The power does not turn on

a. Make sure that the power cord is plugged into a

surge suppressor and that the surge suppressor

is plugged into a properly grounded outlet (see

page 13). Use only a surge suppressor that meets

all of the specifications described on page 13.

IMPORTANT: If the treadmill is connected to an

AFCI-equipped outlet and your circuit breaker

trips repeatedly when the treadmill is used, see

the front cover of this manual to purchase an

arc filter.

b. After the power cord has been plugged in, make

sure that the key is inserted into the console.

c. Check the power switch located on the treadmill

frame near the power cord. If the switch protrudes

as shown, the switch has tripped. To reset the

power switch, wait for five minutes and then press

the switch back in.

SYMPTOM: The power turns off during use

a. Check the power switch (see drawing c at the left).

If the switch has tripped, wait for five minutes and

then press the switch back in.

b. Make sure that the power cord is plugged in. If the

power cord is plugged in, unplug it, wait for five

minutes, and then plug it back in.

c. Remove the key from the console, and then

reinsert it.

d. If the treadmill still will not run, please see the front

cover of this manual.

SYMPTOM: The console displays remain lit when

you remove the key from the console

a. The console features a display demo mode,

designed to be used if the treadmill is displayed in

a store. If the displays remain lit when you remove

the key, the demo mode is turned on. To turn off

the demo mode, hold down the Stop button for a

few seconds. If the displays are still lit, see THE

INFORMATION MODE on page 18 to turn off the

demo mode.

SYMPTOM: The incline of the treadmill does not

change correctly

a. Hold down the Stop button and the Speed increase

button, insert the key into the console, and then

release the Stop button and the Speed increase

button. Next, press the Stop button and then

press the Incline increase or decrease button. The

treadmill will automatically rise to the maximum

incline level and then return to the minimum level.

This will recalibrate the incline system. If the incline

system does not begin calibrating, press the Stop

button again, and then press the Incline increase or

decrease button again. When the incline system is

calibrated, remove the key from the console.

MAINTENANCE AND TROUBLESHOOTING

Reset

Tripped