Pro-Form PFTL13113 オーナーマニュアル

The heart rate  

monitor consists of  

a chest strap and a 

sensor. Insert the 

tab on one end of 

the chest strap into 

the hole in one end 

of the sensor as 

shown. Then, press 

the end of the sen-

sor under the buckle 

on the chest strap. 

The tab should be 

flush with the front of 

the sensor.

The heart rate moni-

tor must be worn 

under your clothes, 

tight against your 

skin. Wrap the heart 

rate monitor around 

your chest in the 

location shown. 

Make sure that 

the logo is right-

side-up. Then, attach the other end of the chest strap 

to the sensor. Adjust the length of the chest strap, if 

necessary.

Pull the sensor away from your body a few inches and 

locate the two electrode areas, which are covered by 

shallow ridges. Using saline solution such as saliva or 

contact lens solution, wet the electrode areas. Then, 

return the sensor to a position against your chest.

•  Thoroughly dry the sensor with a soft towel after 

each use. Moisture may keep the sensor activated, 

shortening the life of the battery.

•  Store the heart rate monitor in a warm, dry place. Do 

not store the heart rate monitor in a plastic bag or 

other container that may trap moisture.

•  Do not expose the heart rate monitor to direct sun-

light for extended periods of time; do not expose it to 

temperatures above 122° F (50° C) or below 14° F 

(-10° C).

•  Do not excessively bend or stretch the sensor when 

using or storing the heart rate monitor.

•  To clean the sensor, use a damp cloth and a small 

amount of mild soap. Then, wipe the sensor with a 

damp cloth and thoroughly dry it with a soft towel. 

Never use alcohol, abrasives, or chemicals to clean 

the sensor. Hand wash and air dry the chest strap.

If the heart rate monitor does not function properly, try 

the steps below.

•  Make sure that you are wearing the heart rate moni-

tor as described at the left. If the heart rate monitor 

does not function when positioned as described, 

move it slightly lower or higher on your chest.

•  If heart rate readings are not displayed until you 

begin perspiring, rewet the electrode areas.

•  For the console to display heart rate readings, you 

must be within arm’s length of the console.

•  If there is a battery cover on the back of the sensor, 

replace the battery with a new battery of the same 

type.

•  The heart rate monitor is designed to work with 

people who have normal heart rhythms. Heart rate 

reading problems may be caused by medical condi-

tions such as premature ventricular contractions 

(pvcs), tachycardia bursts, and arrhythmia.

•  The operation of the heart rate monitor can be 

affected by magnetic interference from high power 

lines or other sources. If you suspect that magnetic 

interference is causing a problem, try relocating the 

fitness equipment.

Sensor Buckle

Tab

Chest 

Strap

Tabs

Sensor