Marvel Kegerator with X-CLUSIVE 2 Faucet D System Keg Tapping Kit - Black Cabinet with Overlay Door 使用とお手入れ
12
TROUBLESHOOTING YOUR REFRIGERATOR
Problem
Possible Cause
Remedy
Unit not cold enough
Adjust temperatures (See “Set the tem-
perature control” on page 4)
perature control” on page 4)
Control set too warm
•
Airflow to front grille blocked.
•
Excessive usage or prolonged door
•
openings.
Door gasket not sealing properly.
Door gasket not sealing properly.
•
Adjust temperature colder. Al-
•
low 24 hours for temperature to
stabilize.
Airflow must not be obstructed to
stabilize.
Airflow must not be obstructed to
•
front grille. See “clearances” on
page 3.
Allow temperature to stabilize for
page 3.
Allow temperature to stabilize for
•
at least 24 hours.
Adjust or replace door gasket.
Adjust or replace door gasket.
•
Unit too cold
Adjust temperatures (See “Set the tem-
perature control” on page 4)
perature control” on page 4)
Control set too cold
•
Adjust temperature warmer. (See
•
page 4, “set the temperature con-
trol”). Allow 24 hours for tempera-
ture to stabilize.
trol”). Allow 24 hours for tempera-
ture to stabilize.
Noise or Vibration
Unit not level
•
Level unit, see “Leveling Legs” on
•
page 3.
Unit will not run.
Unit turned off
•
Power cord not plugged in.
•
No power at outlet.
•
Turn unit on. See “Set the tempera-
•
ture control” on page 4.
Plug in power cord.
Plug in power cord.
•
Check house circuit.
•
Unit runs 100% after initial start-up or
introduction of a new keg.
introduction of a new keg.
The keg is much warmer than the
•
units set-point.
Unit will return to a typical on/off
•
cycle after the keg temperature has
stabilized.
stabilized.
Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshoot-
ing guide below. Locate the problem in the guide and refer
to the cause and its remedy before calling for service. The
problem may be something very simple that can be solved
without a service call. Some remedies listed in the Trouble-
shooting Guide are very complex. Consulting or contracting
a qualified service technician may be necessary.
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshoot-
ing guide below. Locate the problem in the guide and refer
to the cause and its remedy before calling for service. The
problem may be something very simple that can be solved
without a service call. Some remedies listed in the Trouble-
shooting Guide are very complex. Consulting or contracting
a qualified service technician may be necessary.
Electrocution Hazard - Never attempt to repair or perform maintenance on the unit until the main electrical power has
been disconnected.
been disconnected.