Vinotemp Sonoma 800L Wine Cellar - 610 Bottle Count 組み立て手順

Disassemble/Assemble instructions 

 

FOR YOUR PERSONAL WINECELLAR 

 

The tools required for disassembly and reassembly of your custom Winecellar are as follows: 
 

A) 7/16 

Wrench 

B) 

Phillips Head Screwdriver 

C) Metric 

4mm 

Hex Wrench 

D) 

1/4” Nut Driver 

 
You will need a clean level area. It will be necessary for 2 or 

3 

people to help in disassembly to 

complete the following instructions: 
 

1. 

Remove shipping carton and packing material with exception to pallet. Open door 

and 

remove the plastic bag containing four or six casters depending on the size of 

unit. 

 

2. 

Place the cardboard on ground behind winecellar. 

 

3. 

With the 7/16” wrench, remove the two baits at the top of cooling unit. Carefully 
slide the unit out and place it on the ground out of the way in an upright position, 
being careful not to damage the insulated bottom. 

 

4. 

If you have a model 700, remove the middle 

bar 

by removing center screw in 

back brace, then remove screws on top 

and 

bottom of middle bar. 

 

5. 

Carefully remove the screws that are on the cabinet side of the hinge making sure 
someone is holding the door while screws 

are 

being removed. Place the door on 

cardboard to the side of winecellar. 

 
 

6. 

With the Phillips Head Screwdriver or 1/4” Nut Driver carefully remove the 
screws holding the bottle racks, be sure to save the screws which 

are 

located in 

the top back of rack. Remove entire rack. (Standard cellar trellis racks) 

 

Models with horizontal support 

bar 

(single door 440 

and 

single door 400), 

the 

bar 

must be removed prior to removing rack. 

 

Removal of E-Line (Black Metal) Racks: 

-Remove the cellar trellis row sticks from the top of rack.