Electrolux EPWD15IW ユーザーズマニュアル

EXCESSIVE WEIGHT HAZARD

To avoid back or other injury, have more than one person move 
or lift the appliance.

If washer or dryer is new and has not been installed yet, skip 

1. 

to step 4. 

If dryer is already installed, disconnect dryer from electrical 

2. 

and gas connections and exhaust venting. On models with 
Steam Option, turn off cold water supply and disconnect wa-
ter supply hose to dryer.

If washer is already installed, disconnect washer from electri-

3. 

cal connection. Turn off hot and cold water supply and dis-
connect hot and cold water supply hoses from water supply 
outlets. Disconnect drain hose from drain pipe.

Protect fl oor and unit with cardboard or rug and carefully lay 

4. 

the appliance on its side and screw each leg completely into 
the base.

Allow for approximately 5 in. (12.5 cm) behind the pedestal 
for clearance of back of washer or dryer to the wall. Allow an 
additional 3/4 in. (2 cm) for water inlet on Steam Model Dryers 
and additional space if venting dryer upward or downward.

Due to higher center of gravity of appliance on pedestals, some 
side-to-side rocking is normal during operation. Vibration can be 
minimized by assuring appliance is installed properly, including being 
level and solid on all four (4) legs by following these directions.

Prepare appliance for mounting

Prepare pedestal before mounting

Locate pedestal 

1. 

to within a few 
inches of its 
fi nal location.

Level the pedestal 

2. 

front-to-back and 
side-to-side by ad-
justing each leveling 
leg. Keep leg exten-
sion to a minimum.

Rock the pedestal from corner-to-corner to check for stability. 

3. 

Repeat leveling and rocking until all four (4) feet are sturdy on 
the fl oor and pedestal is level.

Without turning the rubber foot, lock each pedestal leg in 

4. 

place by tightening its lock nut tight against the pedestal 
base.

DO NOT use open dispenser drawer of washer or dispenser 
cavity as hand-hold location when tipping washer on its side. 
Serious damage could occur to your washer.

If feet are not completely screwed in, mounting holes in 
appliance will not align to mounting holes in brackets.