Electrolux EI30BM60MS オーナーマニュアル

ページ / 28
E
(Front of microwave oven)
(Rear of microwave oven)
Grease filters
Tabs
BOTTOM VIEW
CLEANING AND CARE
EXTERIOR
The outside surface is precoated steel and plastic. 
Clean the outside with mild soap and water; rinse 
and dry with a soft cloth. Do not use any type of 
household or abrasive cleaner.
DOOR
Disconnect the power cord or deactivate the oven 
with setting Child Lock  before cleaning to prevent 
unexpected manipulation. See Child Lock on page 
21. Wipe the window on both sides with a soft cloth 
to remove any spills or spatters. Metal parts will be 
easier to maintain if wiped frequently with a soft cloth. 
Avoid the use of spray and other harsh cleaners as 
they may stain, streak or dull the door surface. 
EASY CARE™ STAINLESS STEEL 
(SOME 
MODELS)
Your microwave oven finish may be made with Easy 
Care™ Stainless Steel (some models). Clean the 
stainless with warm soapy water using a clean sponge 
or cloth. Rinse with clean water and dry with a soft 
clean cloth. DO NOT use ANY store bought cleaners 
like Stainless Steel cleaners or any other types of 
cleaners containing any abrasive, chlorides, chlorines 
or ammonia. It is recommended to use mild dish soap 
and water or a 50/50 solution of water and vinegar.
INTERIOR
Cleaning is easy because little heat is generated 
to the interior surfaces; therefore, there is no 
baking and setting of spills or spattering. To clean 
the interior surfaces, wipe with a soft cloth and 
warm water. DO NOT USE ABRASIVE OR HARSH 
CLEANERS OR SCOURING PADS. For heavier soil, 
use baking soda or a mild soap; rinse thoroughly with 
hot water. The rack can be cleaned with hot soapy 
water, rinsed and dried.
WAVEGUIDE COVER
The waveguide cover is located on the ceiling in 
the microwave oven cavity. It is made from mica so 
requires special care. Keep the waveguide cover 
clean to assure good microwave oven performance. 
Carefully wipe with a damp cloth any food spatters 
from the surface of the cover immediately after they 
occur. Built-up splashes may overheat and cause 
smoke or possibly catch fire. DO NOT REMOVE THE 
WAVEGUIDE COVER. 
ODOR REMOVAL
Occasionally, a cooking odor may remain in the 
microwave oven. To remove, combine 1 cup water, 
grated peel and juice of 1 lemon and several whole 
cloves in a 2-cup glass measuring cup. Boil for several 
minutes using 100% power. Allow to set in microwave 
oven until cool. Wipe interior with a soft cloth.
TURNTABLE/TURNTABLE SUPPORT
The turntable and turntable support can be removed 
for easy cleaning. Wash them in mild, sudsy water; for 
stubborn stains use a mild cleanser and non-abrasive 
scouring sponge. They are also dishwasher-proof. Use 
upper rack of dishwasher. The turntable motor shaft is 
not sealed, so excess water or spills should be wiped 
up immediately.
GREASE FILTERS
Filters should be cleaned at least once a month. Never 
operate the fan or microwave oven without the filters 
in place.
1.  Pull down slightly on the tab toward the front of 
the microwave oven and remove the filter. Repeat 
for the other filter.
2.  Soak the filters in a sink or dish pan filled with hot 
water and detergent. DO NOT use ammonia or 
other alkali; they will react with the filter material 
and darken it.
3.  Agitate and scrub with a brush to remove embed-
ded dirt.
4.  Rinse thoroughly and shake dry.
5.  Replace by fitting the filter back into the opening.
Disconnect the power cord before cleaning or leave the door open to deactivate 
the oven during cleaning.
ORM 2.0 Bottom [TINSEB310WRRZ] [30   30
ORM 2.0 Bottom [TINSEB310WRRZ] [30   30
10/19/10   1:21:43 PM
10/19/10   1:21:43 PM
22