Electrolux EI23BC35KS オーナーマニュアル

After the refrigerator is installed properly, 

the ice maker can produce ice within 24 

hours. When using the ice maker for the first 

time, and in order for it to work properly, it is 

necessary to clear air from the water tubing 

and the filter. Furthermore, if the system is not 

flushed, the first ice cubes may be discolored 

or have an odd flavor. Once ice maker begins 

making ice, allow the bin to fill completely, 

then discard the first FULL bin of ice on a 

Standard Depth model, and the first TWO 

FULL bins of ice on a Counter Depth model.

This ice maker should produce between 2 and 

2.5 pounds of ice per 24 hours depending on 

usage conditions. In a Standard Depth model, 

the ice bin will hold about 12 pounds of ice. 

In a Counter Depth model the ice bin will hold 

about 7 pounds of ice.

Your ice maker is turned on at the factory 

so it can work as soon as you install your 

refrigerator. If you cannot connect a water 

supply, lift the ice maker’s wire signal arm 

to turn it off. Otherwise, the ice maker’s fill 

valve may make a loud chattering noise 

when it attempts to operate without water.

Ice production is controlled by lifting/lowering 

the ice maker’s wire signal arm. To gain 

access to the ice maker, pull the freezer 

drawer out. Lift the wire signal arm to turn the 

ice maker OFF and lower the wire signal arm 

to turn it ON.

Clean the ice maker and ice bin at regular 

intervals, especially prior to vacation or moving.
  1  Turn off the ice maker.
  2  Remove the ice bin.
  3  Empty and carefully clean the ice bin 

with mild detergent. Do not use harsh or 

abrasive cleaners. Rinse with clean water.

  4  Allow the ice bin to dry completely before 

replacing in the freezer.

  5  Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if an extended 

power failure (one hour or longer) causes 

ice cubes in the ice bin to melt and refreeze 

together after power is restored.
Remove the ice bin and shake to loosen the 

cubes or clean as explained above.

If the water supply to your refrigerator is 

softened, be sure the softener is properly 

maintained. Chemicals from a water 

softener can damage the ice maker.

NEVER use an ice pick or similar sharp 

instrument to break up the ice. This 

could damage the ice bin.
To loosen stuck ice, use warm water. 

Before replacing the ice bin, make sure it 

is completely dry.

•  The following sounds are normal when 

the ice maker is operating:

 

-  Motor running 

 

-  Ice dropping into ice bin

 

-  Water valve opening or closing

 

-  Running water

•  Ice cubes stored too long may develop 

an odd flavor. Empty the ice bin as 

explained below.

Your refrigerator is equipped with a Fast 

Freeze Function for freezing food at a faster 

rate, but it can also increase ice production. 

This function terminates automatically after 12 

hours. This function affects only the ice maker 

in the freezer.

Wire

Signal Arm