Electrolux EI23BC35KS オーナーマニュアル

ページ / 49
42
Solutions to Common Problems
Before you call...
If you experience a problem with your refrigerator or notice a product behavior or condition that 
you do not understand, you can usually avoid a call to your service representative by referring to 
this section for an answer. Beginning with the following table, this information includes common 
concerns, causes, and suggested solutions.
Automatic Ice Maker
Concern
Potential Cause
Common Solution
Ice maker is not 
making any ice.
•  Ice maker is turned off. 
 
 
 
•  Refrigerator is not 
connected to water line or 
water valve is not open.
•  The water supply line is 
kinked. 
•  The water filter is not 
seated properly. 
•  The water filter may be 
clogged with foreign 
material.
•  Saddle valve on cold 
water pipe is clogged 
or restricted by foreign 
material.
•  Freezer ice maker wire 
signal arm is being 
held up by an item not 
allowing it to go in the 
on or down position.
•  Turn on ice maker. For the fresh food 
ice maker, press and hold the “Ice 
Off” button for three seconds until the 
indicator light is off. For the freezer ice 
maker, lower the wire signal arm.
•  Connect the unit to the household water 
supply and ensure the water valve is open. 
•  Ensure that the supply line does not kink 
when the refrigerator is pushed into place 
against the wall.
•  Remove and reinstall the water filter. Be 
sure to push the filter firmly so that you 
hear it lock solidly into position.
•  If water dispenses slowly or not at all, or 
if the filter is six months old or older, it 
should be replaced.
•  Turn off household water line valve. 
Remove valve. Ensure valve is not a 
self-piercing saddle valve. Clean valve. 
Replace valve if necessary.
•  Move any item or frozen ice cubes that 
may block the signal arm from being in 
the on or down position. See Automatic 
Ice Maker-Freezer section in manual.