Electrolux E36GF76HPS オーナーマニュアル

Should you ever need to remove the burner caps for cleaning lift the burner cap off the 

burner head. Clean heavy soils with an absorbent cloth. Rinse with a clean, damp cloth 

and immediately 

thoroughly dry including the bottom and inside of the cap. Do not use 

harsh abrasive cleaners. They can scratch the porcelain on the cap. Do not clean burner 

caps in dishwasher. 
When placing the burner caps, see Important note below.

The glass in the double ring is designed to fit loosely. Clean with normal non abrasive glass 

type cleaner and thoroughly dry before replacing. 

Lift the burner cap from the burner head. The surface burner heads are secured to the 

cooktop and 

must be cleaned in place.

For proper gas flow it may be necessary to clean the burner heads and slots. To clean, first 

use a clean DAMP cloth to soak up any spills. Remove any food from between the burner 

slots using a small nonabrasive brush like a toothbrush and afterwards wipe using a damp 

cloth. For stubborn soils located in the slots, use a small-gauge wire or needle to clean.

Should you experience ignition problems it may be that an ignition port hole is partially 

blocked with soil (see figs 1 & 2). With the burner head in place, use a small wire gauge 

needle or the end of a paper clip to clear the ignition port or ports.

When placing the burner caps on the cooktop, be sure the burner caps are seated firmly on top of burner 

heads. Improper flame size and uneven heating may result when any surface burners are turned ON and 

the burner caps are not seated correctly.

Figure 1 - Cooktop burner head

(All burners except Double ring burner)

Slots

Slots

Ignition port

Ignition 

port

Orifice 

port

Orifice port

Figure 2 - Double ring burner head

(Models equipped with double ring burner only)